Beli engine hanger di monotaro.id

When lifting the engine, you can tilt the engine in a hung state at the time of engine detachment. The angle of the engine can be changed to the angle of your choice with your existing tool, so working efficiency will increase.Dokumentasi Produk:WARRANTY MonotaRO Private Brand

As Joint bracket

The Westward® engine load leveling sling is designed to be used between an overhead lifting hoist and an unevenly weighted load such as an auto engine with transmission intact. This engine leveler can increase efficiency in a variety of hoisting applications by allowing the operator to lift off-center loads and adjust the working angle of the loads. Adjust is secured with locking boltsIncludes a crossbar and 2 sling hooks

Ideal for home workshops or garages. Folding design for easy storage and transportation. Flow control valve for precise lowering and positioning. Overload safety valve. Hydraulic operation providing easy lifting. Heavy duty swivel hook with safety latch. Four different jib options. Heavy duty castors. Model number..........FMC001. Order Code..........KEN-985-3670K. Lifting capacity position (a)..........1,000kg. Lifting capacity position (b)..........750kg. Lifting capacity position (c)..........500kg. Lifting capacity position (d)..........250kg. Maximum lifting height at minimum jib extension..........1868mm. Maximum lifting height at maximum jib extension..........2004mm. Length of jib in position (a)..........865mm. Length of jib in position (b)..........955mm. Length of jib in position (c)..........1045mm. Length of jib in position (d)..........1135mm. Clearance height of legs..........130mm. Length of frame..........1480mm. Overall clearance height..........1555mm. Maximum width of frame..........1000mm. Distance between rear wheel centres..........640mm. Weight..........91kg. 1 tonne (metric ton or t) = 1000kg 1 ton (imperial ton) = 2240lbs (1016kg)

Helmet for storage

-It is a special tool for holding automobile engines. -It corresponds to the engine of a normal car from a mini car of FF car. (Excluding fenders, strut towers, vehicles without front support mounting bolts, trucks, and 1BOX) -Maximum working load: 2,450N (250kgf) or less -Compatible with shock-absorbing body vehicles that have been used in many vehicles in recent years. -Even if the fender is slanted or the front is lowered, it is possible to set it parallel to the ground with a stable setting. -Short fender ribs, which cannot be used with conventional products, can be used for vehicles that cannot be set between fenders. -It is possible to move the vehicle and lift up and down while the engine is held. -Because the bridge can be set diagonally, it can be used by shifting the bridge from the belt when performing work such as changing the belt. - Uses a retrofit winch. The drive unit can be easily changed to the left or right, and can be moved to any position. -The winch can be operated remotely using the chain wheel even when the vehicle is lifted up. *Cannot be used on vehicles with resin set points or vehicles without mounting bolts at the set points. (Set point: bolt that sets the foot)